Blog | A&B Jukebox Repair

How to: Install & Use JukeCD Software 5.2

Video tutorial included. JUKECD 5.2 software by Low Profile. If you have a problem getting your software to load, there are instructions her

Programming a CD-100 Jukebox

*CD 100 Programming Info taken from CD 100 service manual Putting in new CD’s Put the service switch to service, when you have the jukebox in service you can press the cancel button located on the front top left corner of the Mechanism frame and the Mech Magazine will spin counter clockwise. Go ahead and move the mechanism to any open position that you want, then slide in the CD into the open slot in the magazine. Make sure that CD label is facing to the right and CD playing surface is to the left. Make sure that you properly alien each CD as you put them in. Once you have completed putting in the CD’s you need to take the service switch out of service and put it to the Norm playing position

How to: Install a CDM-4 Player

Are you unsure how to install a CDM-4 Player? Here are all the steps you need to know. After reading, if you're still having trouble, please feel free to call us at 603-382-2595. This 'How To' article was previously posted on YouTube. Click here to check watch the video version. Before getting started: Make sure that the power is off to the Jukebox before replacing the player. Failure to do so could result in damaging the CD player or the mechanism control computer and voiding out the warranty. It is best to unplug the Jukebox. Step 1: Loosen the two L brackets on top of the player and move them to the side or take them completely off. Always touch a piece of metal on the jukebox to discharg